- ページ 2
ホットタブ aqua living Catalina Luxury BerkshireのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。aqua living Catalina Luxury Berkshire 8 ページ。
ページを印刷する
CirCuit Breaker OptiOns with prOperly wired GFCi
Before proceeding, read & follow complete electrical requirements & recommendations that begin on page 8 of your spa manual.
Primary pump only circulates on low speed
Model
Armstrong
Kennedy
Berkshire
Carlton
Hampshire
Nantucket
THE EQUIPMENT BAY
Before the spa can be filled with water or connected to the power supply, you'll
need access to the equipment bay, which houses most of the spa components
including the pumps and electronics.
THE ACCESS PANEL
The equipment bay is located inside the cabinet on the same side as the
topside controls.
•
Remove the screws from the panel under the topside control and
store the panel and the screws safely aside.
THE DRAIN VALVE
Rotate the twist valve to open and close the drain.
•
When filling your spa, make sure the drain is completely closed.
•
When draining your spa, remove the cap & attach your water hose. When
finished, close the drain, remove the hose & replace the cap. Connecting
your water hose allows you to control where water goes as the spa drains.
THE UNIONS
The primary causes of leaks inside the cabinet are unions that need to be
tightened and seals that are improperly seated or need to be replaced.
•
Hand tighten unions each time you fill your spa or remove the access panel.
•
Never tighten with a wrench or other tool.
THE SLICE VALVES
Slice valves are installed in the plumbing lines so service can be performed without
draining the spa. Pushing them down creates a seal that blocks the flow of water.
•
When the GFCI is on, T-Stems must always be locked in the up position.
•
Make sure the T-Stems are up and the locks are in good condition each time
you remove the access panel.
2 Luxury Collection
during heating cycles
50 amp
50 amp
50 amp
50 amp
Primary pump operates normally even
during heating cycles
50 amp
50 amp
60 amp
60 amp
60 amp
60 amp
www.CatalinaSpas.com