- ページ 3

ダイビング機器 Aqua Lung 63093のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aqua Lung 63093 8 ページ。 Slt neck & wrist seal

5. Push the Neck Tite Tool forward along the Lock Ring until all of it has been force

into the groove in the Neck Ring. (Strive to get the same amount of excess part of

seal around the entire assembly, see image 6 of this section)

6. Ensure that the excess part of the seal is similar throughout the entire dressing. We

recommend between 1.5-2cm.

7. Check that the Lock Ring is in position by following the groove 360˚.

8. After completing the seal attachment section, perform a security check: Grab the

end of the seal as the image shows and pull it gently away from the joint to ensure

that it is seated properly. Do not use excessive force! Simulate the same force as

used when donning the suit.

1.5-2cm

MOUNTING THE NECK SEAL

ENGLISH