- ページ 11

クワッドコプター DF-models Sky WatcherのPDF マニュアルをオンラインで閲覧またはダウンロードできます。DF-models Sky Watcher 19 ページ。

Calibrate gyroscope

When the flight of the drone is unstable or deviated from the left and

right after take-off, the consumer can correct the gyroscope and the

flight will be more stable after the correction.

1.Place the drone on a flat ground, then pull the left joystick to the

bottom, while turn the right joystick left and right horizontally quickly and

without stop until the lights on the drone start flashing slowly. (The front

and rear lights on the drone flash slowly to indicate that calibration has

been entered, DO NOT move the drone at this time.)

2.Waiting for the front and rear lights of the drone to flash quickly which

indicates that the calibration was successful.

The remote control throttle of the factory products defaults to the

left-handed joystick. Consumers can switch between left and right hand

mode according to the following operations. Consumers only need to

switch once, the remote control can save it automatically, no need to

switch it again in next flying.

Press and hold button 9, and turn on the power switch of the remote

control and then release the 2 buttons (the remote control indicator light

flashes quickly), then push the right joystick to the top for two seconds,

when the remote control indicator light turns RED and flashes slowly,

pull the right joystick to the bottom for two seconds. Waiting for the

remote control indicator light to turn to a green light, that indicates the

switch is successful.

Press and hold button 10, and turn on the power switch of the remote

control and then release the 2 buttons (the remote control indicator light

flashes quickly), then push the left joystick to the top for two seconds,

when the remote control indicator light turns RED and flashes slowly,

pull the left joystick to the bottom for two seconds. Waiting for the

remote control indicator light to turn to a green light, that indicates the

switch is successful.