- ページ 5

クワッドコプター DF-models Sky WatcherのPDF マニュアルをオンラインで閲覧またはダウンロードできます。DF-models Sky Watcher 19 ページ。

Pairing your drone to the controller

power swith

Don't fly the drone in rainy, foggy, snowy, windy

(wind speed above 4 meters) days!

1. Firstly, switch on the remote and then LED on the remote will become

red and start flashing. Secondly, switch on the drone and place the

drone standing on the floor, the code transmitted from the remote will be

successfully paired by the receiver from the drone once the remote

sounded "di,di" twice. )

2. Push the left joystick on the remote control to the top for two seconds,

then pull the left joystick to the bottom for two seconds.

(At this time, the remote control indicator light turns to green color and

flashes slowly.) Release the left joystick, when the front and rear lights

of the drone flash quickly at the same time, the frequency pairing is

successful.

3. When both of the front and the back indicator leds stop flashing and

stay stable, then the drone is successfully matched GPS signal and

ready to fly.

4. When the end user firstly fly this drone, he or she will need to

recalibrate the geomagnetism before reflying if the drone can not fly

stably after many crashes or changing engines.

(1).Press and hold the normal mode button, the red lights on the rear of

the drone will be off, and the front green lights will flash quickly to enter

the calibration. The normal mode button can be released at this time.