- ページ 6

安全装置 Aqua Lung 769161のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aqua Lung 769161 16 ページ。 Surface supplied harness

Securing Cylinder to Harness

1. Wet the cylinder bands and then slide them over the cylinder

so that the harness is at the desired position in relation to the cyl-

inder valve. make sure the cylinder valve air outlet is facing toward

the diver's back. pull the cylinder keeper tight to the cylinder and

secure the hook and loop. While holding the cylinder secure, pull

thefreeendoftheuppercylinderbanduntilthereisaverytightfit

between the harness and the cylinder. repeat process on lower

band (See Fig. 8).

2. Close the buckle halfway to hold the cylinder band taut, and

thread the free end of the band through the open slot in the end of

the buckle (See Fig. 9).

3. Pull the cam buckle closed so that it lies flat against the

cylinder. Secure the end of the cylinder bands with the hook

and loop attachment. test the tightness by pushing/pulling the

harness (See Fig. 10).

WARNING: the cylinder band will initially stretch as it becomes wet. Always wet the band

before making the final adjustment; apply enough tension to ensure that the cylinder is

completely secure. test this connection before every dive.

Surface Supplied Harness User's Manual

Fig. 8

Fig. 9

Fig. 10

Check all 3

bands are

secure