- ページ 8

水族館 Aqua Medic reactor 1000のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Medic reactor 1000 10 ページ。 Co2-reactor
Aqua Medic reactor 1000 にも：操作説明 (5 ページ)

ページを印刷する

2. Set Up/Installation

The reactor 1000 has two hose connections for 16/18 mm hose and may be used externally or

internally.

- Mounting inside the aquarium:

The included holding system allows easy fixing of the reactor at or inside of the aquarium. The

holder is mounted on a vertical or horizontal glass stripe and secured by 2 screws.

- Mounting outside the aquarium:

The reactor 1000 may be mounted at a wall or inside the aquarium cabinet. Put a piece of

plywood behind the holding plate and screw the plate directly to the wall or aquarium cabinet. If

the reactor 1000 is used externally, make sure that both water connections are tightened and the

O-rings (9) are correctly mounted.

Now, both holding clamps (7) are mounted and the reactor 1000 is pressed into the clamps.

Water inlet: The water inlet is connected to the upper hose connection of the reactor 1000 (2).

For the water supply, a separate pump (min. 1,000 l/hr , 250 gph) or the water outlet of a canister

filter may be used. A stronger circulation improves the solution of the carbon dioxide. If the

circulation pump is too strong, the reactor can be mounted in a bypass.

Water back flow: The lower connecting piece of the reactor 1000 will be connected with a hose

12/16 mm, back to the aquarium.

The CO2 is connected to the pressure fitting (3): Make sure, that a non-return valve is mounted

between the reactor and the bubble-counter of the CO2-unit. The CO2 is directed downwards inside

the reactor with a hose. By this counter-current flow, the dissolving of gas is optimized. The

Bactoballs give an extra turbulence.

Ventilation: The air in the reactor can be removed by the valve (4) during starting. Also the false

gas which can accumulate in the reactor during operation, can be absorbed by opening the tap for

a short time.

Please take always care that the hoses do not bend.

Technical Data

Unit reactor 1000

Water connection port:

CO2-connection:

Water flow:

Set up:

3. Appliance/Setting

A pressure regulator has to be installed onto the CO2 store bottle before the CO2 reactor can be

set up.

Please read the operation manual relating to this device carefully. We recommend the pressure

regulator regular of our CO2 program.

After having installed the pressure regulator and the CO2 reactor as stipulated, the setting up of

the CO2 reactor can be started.

1. Switch on the circulation pump for the water flow.

2. Open the main valve of the CO2 bottle.

3. Fix the working pressure on the pressure regulator to 1 – 2 bar. The working pressure of the

regular is fixed to 1,5 bar.

4. Open the fine tuning valve of the pressure regulator slowly. When doing so, control the outgoing

CO2 bubbles of the bubble-counter.

5. At first, fix 15 bubbles per minute.

6. The CO2 gas flows into the reactor and is absorbed by the running water.

Art.-No: 71113

12/16 mm

6/4 mm

min 1.000 l/h

internally or externally