- ページ 3

ステレオシステム Avol AMB620iのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Avol AMB620i 6 ページ。 Multimedia audio system for your ipod

ページを印刷する

Power Supply

Connect to Power Source

Connect the

mains adaptor DC 9V into DC IN Jack

and the other end into the wall socket.

The wall

outlet must be located near the product and be easily

accessible.

Helpful hints: To avoid damage the set, use only the

adaptor supplied!

The type plate is located on the back of the set.

Replacing Backup Batteries on Unit

Install/Replace Backup Battery

These set uses a backup battery system to provide

continuous alarm operation and clock settings in the

event of a power failure. If the clock or alarm not work, it

is time to replace the backup batteries. Please make sure

the AC adaptor is connected, otherwise all settings may

be lost during battery replacement.

Open the battery compartment cover located on the

bottom of the unit. Insert 2 "AAA" size batteries as

indicated. We recommend the use of alkaline

batteries for longer life.

Batteries information:

Do not mix old and new batteries.

Do not mix alkaline, standard (carbon-zinc) or

rechargeable (nickel-cadmium) batteries.

Install/Replace the Remote Control Batteries

The remote control batteries are already installed at the

factory. Remove battery insulator tape before use. When the

remote control stops operating or its range seems reduced,

replace the batteries with new ones.

The battery door is located on the back of the unit.

Pull the battery door out.

3. Insert one "CR2032" 3-volt lithium batteries. Make sure

the polarity (the + and - side of the battery) is correct.

Fully insert the battery door back to the original position.

NOTE:

Battery contain chemical substances, so they

should be disposed of properly.

DC IN

Battery door

ENG-4

Basic Operation

Switching on the system

Press

POWER ON/OFF for 2 seconds

and the LCD display is on with backlighting. (The system will

switch to the last selected source.)

Press MODE to select function mode (RADIO/IPOD/USB/CARD/AUX).

Switching the system to standby mode

In any source mode, press

POWER ON/OFF

Switching off the volume temporarily

Press MUTE on the remote control to stop sound playback instantly.

Playback will continues without sound and the display shows MUTE.

To start sound playback, press MUTE again, adjust the volume controls or change source.

Setting the Clock

Press and hold MEMORY/SET to select 12 Hours/24 Hours mode.

Press MEMORY/SET once, then clock digits for hours flashes. Press SKIP+/- repeatedly to set and

adjust the hours.

Press MEMORY/SET once, then clock digits for minutes flashes. Press SKIP+/- repeatedly to set and

adjust the minutes.

Press MEMORY/SET to confirm.

Using the Alarms

General

Two different alarm times can be set. This can be useful when you need to be woken up at a different time

e.g. During the week and at the weekend, and you can set different wake-up modes:

BUZZER→RADIO→IPOD→USB→CARD

Setting the Alarms

In any mode, press hold ALARM 1 or ALARM 2 for two seconds. (ALARM 1 / ALARM 2 icon and the hour

digits flash.)

Hold down or press SKIP+/SKIP- repeatedly to set and adjust the hours.

Press ALARM 1 / ALARM 2 to confirm. (ALARM 1 / ALARM 2 icon and the minutes digits flash.)

Hold down or press SKIP+/SKIP- repeatedly to set and adjust the minutes.

Press ALARM 1 / ALARM 2 to confirm and then select your choice of alarm mode: BUZZER→RADIO→

IPOD→USB→CARD

Press ALARM 1 / ALARM 2 to confirm.

At the set alarm time, the BUZZER, RADIO, IPOD, USB or CARD will switch on automatically.

Arming and Disarming Alarm (Turn Alarm ON/OFF)

Slide up ALARM ON/OFF button to arm or disarm functions. When armed, the related alarm icon

appears in display.

Resetting the Alarm to Come on the Next Day

When the alarm is sounding, slide up ALARM ON/OFF button to stop alarm and reset it to come on the

following day.

Snooze

Press the SNOOZE button after the alarm sounds. The alarm will be silenced and come on again 9

minutes later. Snooze can be pressed several time during 1 hour alarm cycle.

Helpful hints:

If you have selected RADIO alarm mode, make sure you have properly tuned to a station before tuning

off the set.

If you have selected IPOD alarm mode, make sure you have docked the compatible player.

If you have selected USB or CARD mode, make sure you have inserted USB or CARD into related jack

before tuning off the set.

To check the alarm time setting for ALARM 1 or ALARM 2, press ALARM 1 or ALARM 2 button.

ENG-5