セキュリティセンサー CP EBDHS-KNXのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。CP EBDHS-KNX 18 ページ。 Ceiling pir hs presence detector
ページを印刷するEBDHS-KNX
Ceiling PIR HS presence detector – KNX
Front features
Mounting Bezel
Back features
Retaining Spring
Switch Input
Connector
Retaining Spring
Product Guide
The EBDHS-KNX PIR (passive infrared) presence detector
provides automatic control of lighting loads with optional
manual control. The EBDHS-KNX is a high sensitivity PIR
detector suitable for high bay applications, such as
warehouses and factories, and where high detection
sensitivity is needed. The device is designed to be part of a
KNX system.
Features include.
All functionality is fully programmable using the KNX ETS
commissioning software.
PIR Sensor
Detects movement within the unit's detection range,
allowing load control in response to changes in occupancy.
IR Receiver
Receives control and programming commands from an
IR (infrared) handset.
Light Level Sensor
Measures the overall light level in the detection area
Status LEDs
Sensor Lens
which covers...
The LED flashes Red to indicate the following:
PIR Sensor
Walk Test LED active
IR Receiver
Light Level Sensor
Valid IR setting received
Status LEDs
KNX Programming LED
The LED lights when the device is placed in programming
mode via the button or IR remote. In programming mode,
the Status LED will mimic the programming LED (i.e. will be
on for the duration of programming mode).
KNX
KNX Programming Mode Button
Communication
LED
Press to signal to the KNX network to enable the system to
discover the device. This can also be done via the IR
handset.
KNX
Program
Switch Input Connector
Button
Two inputs can be used to perform several configurable
functions, for example, dim up / down, scene recall and
KNX
also contribute to logic functions.
Connector
Two switch inputs to manually override the dimming
levels and / or override the lights on or off.
KNX programming mode accessible with IR handset
and also by using the push switch on the back of the
unit.
Programmable logic block. This allows conditions to
be set. For example: send the occupancy telegram
only if the switch is pressed and the lux is low.
Full scene selection functionality selectable via the
IR handset (UHS7 ), eg: scene, on, off, raise and
lower .
Overview
Features
when movement is detected