- ページ 2

制御システム CP Electronics Rapid EBR-4SCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CP Electronics Rapid EBR-4SC 2 ページ。 Scene select plate

ページを印刷する

Programming

Enter programming mode by pressing

the following sequence of buttons within

5 seconds.

All LEDs will flash to indicate the scene

plate is in programming mode.

Set the required light level for this

circuit:

Technical Data

Supply voltage DC

Terminal capacity

Humidity

Operational temp. ºC

Material (casing)

Compliance

For further compliance information visit

www.cpelectronics.co.uk/compliance

IMPORTANT NOTICE!

This device should be installed by a

qualified electrician in accordance with

the latest edition of the IEE wiring

regulations.

Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.

Choose the scene number to

program. Press and hold the requisite

button to get scenes 5 - 8.

To confirm the selection press:

Repeat steps 4 and 5 for all circuits

required.

To cancel the current values and revert

back to the stored setting, press:

12V

1.5mm²

5 to 95% non-condensing

-10 to 35

Flame retardant ABS and PC/ABS

EMC-2014/30/EU

LVD-2014/35/EU

Choose the circuit ID this applies to (do

this even if the circuit ID is the same as

the scene number). Press and hold the

requisite button to get circuit ID 5 - 8.

To confirm the selection press:

To store the scene setting repeat step 1

above.

If no keys are pressed for more than 5

minutes, you automatically exit

programming mode and no changes are

saved.

C.P. Electronics Ltd

Brent Crescent

London

NW10 7XR

United Kingdom

Tel:

+ 44 (0) 333 900 0671

Fax:

+ 44 (0) 333 900 0674

www.cpelectronics.co.uk

Ref: #WD243 Issue 5