- ページ 8

キッチン＆ランプ; バス備品 Billi Quadra 440のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Billi Quadra 440 12 ページ。 Tower dispenser
Billi Quadra 440 にも：インストレーション・マニュアル (8 ページ)

ページを印刷する

Installation guide

Billi Quadra – Firewall Tower

Commissioning – Quadra

Turn On the Water Supply

Turn on the water supply tap and ensure that

there are no leaks. Remove front panel of unit

and remove packing foam from under filter

canister. Ensure filter canister is securely

locked back into place. Replace front panel.

Turn On Electricity

Turn on power switch. Check normal time

display is showing. Status line should display

'INITIAL FILL'. Boiling and chilled water tanks

are now filling. Dispenser icons flash orange

slowly.

Cold Water

During

the

initial

automatically opens to fill the cold tank. After

approximately 1 minute, cold water will begin to

flow from the dispenser outlet. Water will

continue to run for a further minute to flush and

condition the filters.

IMPORTANT: Container should be placed

under the dispenser outlet to collect any

water being dispensed during the filter

flush.

Hot Water (Auto Boiling Calibration)

Auto Boiling Point Calibration: The hot tank will

first fill to the height of the low level sensor. The

water is then heated until it reaches boiling

point. The unit will continue to boil for up to 30

seconds

while

the

calibrates.

WARNING: Steam and small amounts of hot

water may be discharged from the outlet

and

vent

during

calibration is underway the hot water

indicator will flash yellow. The hot water set

point is calibrated 1.5°C below the boiling

point. Once calibrated, the unit will resume

normal operation and the calibration data

will be saved. The unit will not re-calibrate

under normal circumstances.

fill,

cold

water

valve

temperature

sensor

this

period.

While

Setting the Programs

The Quadra operational settings have been

factory set for a typical installation. Clock is set

to Eastern Standard Time (EST). Refer to

Quadra User Guide for setting instructions. In

some installations, boiling water delivery

settings may need to be changed as outlined

below.

Tube length setting

The Quadra's boiling water flow rate slows

briefly as water first enters the cup to prevent

splashing. Correct timing of the moment of

reduced flow is dependent on the length of the

tube between the Quadra module and the

dispenser. The standard timing is set for a tube

length of 500mm but this setting can be simply

altered to suit the installation. After installation,

measure the length of the red tube from the

underside of the dispenser to the boiling water

outlet fitting. If the measured length is less than

450mm or greater than 550mm, the correct

value should be set in as follows:

1. Press

SELECT. Display changes to

menu selection mode.

2. Press

DOWN 4 times. Shaded curser

shows 'INITIAL SETUP'.

3. Press

SELECT. Display shows:

Press

SELECT. '0500 mm' flashes.

Press

buttons to enter the correct

tube length.

Press

SELECT.

Press

BACK twice to return to normal

display.