- ページ 2

キッチン＆ランプ; バス備品 Billi XI Slimline FontのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Billi XI Slimline Font 8 ページ。 Proud & flush mount

ページを印刷する

Installation requirements.

Proud & Flush Mount

Components included

Before commencing installation, ensure

you have identified the following pieces:

1. Font tray

2. Font cover plate set 1 set (3 piece)

3. Sealing Gaskets x 3

Drain adapter

5. O-ring

6. M5 x 40mm screw

7. Elbow 3/4"

8. Bush

9. Hose adaptor

10. M6 x 45mm hex bolt x 4

11. M6 Flange nuts x 4

12. Font washer

13. Font mounting bracket x 4

Determine unit location

Plan the installation. Dispenser tube lengths,

benchtop and cupboard restraints and drainage

requirements must be considered when

determining location. Use template enclosed

for drilling and cut-out details. Refer also to

appliance installation requirements supplied

with Drinking Water System.

Drainage location

Careful design and installation is essential

to provide satisfactory drainage performance

and to prevent later blockages. The Billi Font

is designed to be able to be connected to

a dishwasher nipple using either flexile or

rigid tubing or copper tubing. Where a

horizontal run is needed, we recommend

20mm or 25mm copper tubing be used.

An adapter bush is supplied for use where

a standard 40mm trap and drain is installed.

IMPORTANT

If drain is to be connected to a dishwasher

nipple, ensure hole through nipple is drilled

to at least ø12.7mm (1/2") and de-burred,

to allow adequate flow.

Drain must be installed with a continual

fall along the entire length of the tube.

The Billi Fixture is to be installed by

a licensed tradesperson in accordance

with as 3500.4 Or AS/NZ 3500.4.2

And in compliance with applicable

state regulatory requirements.

Font tray

O-ring

Drain adapter

M5 x 45 screw

Diagram 1