- ページ 2
ホットタブ Aqua Pulse Spas Byron Luxury SpaのPDF スタートアップ手順をオンラインで閲覧またはダウンロードできます。Aqua Pulse Spas Byron Luxury Spa 5 ページ。
ページを印刷するBYRON LUXURY SPA 1500 LITRES WEEKLY CHEMICAL INSTRUCTIONS
EACH TIME THE SPA IS COMPLETELY FILLED WITH FRESH WATER
Note: Detergents will cause foaming in the water. To avoid foaming do not allow any body lotions or swimmers
which have been through your washing machine to enter the water. You may need to shower prior to using your
spa and with your swimmers just rinse them off and hang them out to dry.
Place a
Nature 2 Stick
Dispose of the two yellow sticks inside the box and just use the larger section of the Nature 2 Stick.
With supplied cable tie, attach the nature 2 stick to the leaf catcher to prevent it from falling into the spas plumbing.
Add 48g
Granular Chlorine.
of
Use a bucket and scoop some of the spas water into the bucket until it is roughly ¾ full, then add the granular
chlorine to the bucket of water and stir (avoid contact with your skin), after 60 seconds pour the water from the
bucket into the spa and run jet 1 for 5 minutes.
Do not put any of the chlorine granules left in the bucket into the spa they need to be thrown out.
Chlorine granules will damage your spas acrylic and parts, which will void their warranty.
Note: GRANULAR CHLORINE IS COROSIVE. Be careful not to contact yourself or the spas acrylic, cabinet, head
rests or hardcover with the chlorine as it will cause damage. We recommend you remove the spas headrest prior
to using the granular chlorine and replace them the next day to avoid discolouration.
Balance the pH, Alkalinity & Calcium Hardness in the water by following the instructions listed below under
ONCE A WEEK
Note: Unbalanced pH, Alkalinity & Calcium Hardness will damage your spas parts and void your spas warranty.
AFTER EACH USE OF THE SPA
Add 22g
of
Spa Shock #8
ONCE A WEEK
Add 22g
once a week of
Clean the filters.
Remove the filters from the spa and wash thoroughly with a garden hose, then place the filters in a bucket of cold
125ml
water and add
of
water and leave the filter submerged to soak for 24 hours.
After 24hours remove the filters and wash them thoroughly and allow them to completely dry out.
It is recommended to have spare filters to rotate when cleaning the filters each week.
Top the spas water up with at least two buckets of fresh water.
Balance
the spas water using
Use the readings you get off the test strips to balance the:
Free Chlorine, pH & Alkalinity
To Balance your Calcium Hardness, you need to take a sample of your spas water into a
pool or spa store for accurate testing.
Do not use any brand of Test Strips to balance Calcium Hardness.
Visit: www.aquapulsespas.com.au
on the spas leaf catcher inside the filter box.
Add straight into the spas water and run jet 1 for 5 minutes to mix it in.
Spa Shock #8
Add straight into the water and run jet 1 for 5 minutes to mix it in.
Filter Cleaner & Degreaser #9 or Filter Cleaner & Degreaser 1Litre Bottle.
3 in 1 Test Strips
Agitate the