ページを印刷するSetting Up The Phone
A B A K A F O N E
1. Plug handset spiral cord to telephone base and handset.
2. Plug ethernet cable to LAN port at the back of the phone base
and the other end to an RJ-45 port of router or modem.
3. Plug in the power adaptor.
4. Display should read 'Booting...' for a few seconds then goes
to normal display.
S E T T I N G S
1. DATE
At standby state, press SET to enter date setting, LCD will display"
SET 1 DATE" and press SET to confirm. LCD will display "2004"
and "4" will flash, press UP/DOWN to adjust YEAR and press SET
to confirm, and then MONTH will flash, press UP/DOWN to adjust
month and press SET to confirm. The date setting is the same as
year and month. After setting, press SET to enter the next setting
or press EXIT to quit.
2. TIME
Press SET to enter and press UP/DOWN continually until LCD dis-
plays " SET 2 TIME", press SET to start timer setting. Input
HOUR, MINUTES by key number directly. After setting, press SET
to enter the next setting or press EXIT to quit.
3. ALARM
Press SET to enter and press UP/DOWN continually until LCD dis-
play " SET 3 ALARM". Press SET again, LCD will display "SET
ALARM 1". Press SET, LCD will display " ALARM ON". Press UP/
DOWN to select ON/OFF. If ON is selected, press SET to enter
alarm time setting, input alarm time on key pad directly. After en-
tering, press SET to confirm and enter into the ALARM 2 setting.
Setting Alarm 2 and 3 are the same as above. Press EXIT to quit.
Page 4
To Order Call: 1 866 97 ABAKA