- ページ 4

はしご Aqua Select 832406KLのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Select 832406KL 6 ページ。 Hi-rise reverse bend stainless steel in pool ladder w/resin steps

ページを印刷する

• Place the bottom step(BS BOTSTEP) on the

floor facing up. Hold the ladder assembly

straight up and align the pivot balls with the

receivers on the bottom step.

• Push down firmly until both balls are inserted

into the step. See figure 5.

Figure 6

STEP 4

• Slide the pivot balls (BS STPBALL) onto the

• Make sure both pivot balls are securely

Figure 4

STEP 5

STEP 6

• Place ladder in your desired position on deck (A).

Swivel step if needed to align with pool floor.

Make sure the base step rests flat against the

pool floor. (B)

• Mark the location of the handrails on the deck with

a pencil. Using a 1 ½" hole saw, drill one hole for

each hand rail through the deck surface. (C) This will

ensure that the deck will now support the ladder.

• Secure hand rails to the deck using deck flanges (D).

(FLANGES ARE SOLD SEPERATELY)

• Slide the flanges over each handrail. Insert the

handrails through the holes in the deck. Secure the

flanges to the deck with screws. Secure the flange

to the handrail by tightening down the screw in the

flange.

bottom of each handrail as shown in figure 4.

fastened to each handrail.

Figure 5