- ページ 14

水ポンプ CPE C100のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。CPE C100 18 ページ。 Portable centrifugal pump with vfd digital speed control

VFD DIGITAL SPEED CONTROL

FEATURES

The CPE Adjustable Frequency Drives are variable speed controls housed in a rugged NEMA-4X /IP-65 wash-

down and waterlight die-cast aluminum enclosure. They are designed to operate 208-230 and 400/460 Volt 50 &

60 Hz 3-phase AC induction motors from subfractional thru 5HP. The sine wave coded Pulse Width Modulated

(PWM) output provides high motor efficiency and low noise. Adjustable Linear Acceleration and Deceleration

make the drive suitable for soft-start applications.

The 4-Digit LED Display provides readout of drive operating parameters and programming functions and dis-

plays Output Frequency, Motor RPM, Output Current, Output Voltage, Bus Voltage, Function Codes and Values,

Faut Codes and Custom Units. In addition to operating the drive, the Multi-Function Keypad is used to change

drive operating parameters, reprogram functions, and change the display output.

Your drive has been programmed with the correct settings for optimal performance. DO NOT change the param-

eter settings without contacting the factory. THIS WILL VOID THE WARRANTY.

Main Features

Adjustable RMS Current Limit and l2t Motor Overload Protection. *Flux Vector Compensation with Static

Auto-Tune and Boost provides high torque and excellent load regulation over a wide speed range. Power Start

delivers over 200% motor torque to ensure startup of high frictional loads. Programmable Injection Braking pro-

vides rapid motor stop. Electronic Inrush Current Limit (EICL) eliminates harmful AC line inrush current, which

allows the drive to be line switched. A Multi-Function Output Relay is provided, which can be used to turn on or

off equipment or to signal a warning if the drive is put into various modes of operation. Models KBDA-29**.45,48

also contain AC Line Phase Loss Detection.

*UL approved as an elactronic overload protector for motors.

**When used on 3-phase AC line input set for 7.0 Amps or higher (3HP(2.25kW)).

Standard Features

Industrial Duty Die-Cast Aluminum Enclosure with Hinged Cover in a dark gray finish.

Multi-Function Keypad- The keys are used to operate the drive, change operating parameters, reprogram func-

tions, and change the display output (Run/Stop, Forward/Reverse, Up, Down, Shift/Reset, Jog-Local/Remote,

Program/Display, Read/Enter).

4-Digit LED Display - Provides readout of drive operating parameters and programming functions. Displays Out-

put Frequency, Motor RPM, Output Current, Output Voltage, Bus Voltage, Function No. Codes and Values, Fault

Codes, and Custom Units.

LED Status Indicators-The LEDs provide indication of the drive's status and operating mode (Hz, PGM, LCL/REM,

STOP, FWD, REV, OL, JOG/REM).

Multi-Fuction Output Relay Contacts -Can be used to turn on or off equipment or to signal a warning if the drive

is put into various mades of operation. (The optional IODA Input/Output Multi-Function Board contains 9 digital

and analog outputs, and 2 additional relay outputs.)

Motor Current Selection - Programmable motor current allows the drive to be used on a wide range of motor

horsepower.

Compatible with GFCIs.

cpesystems.com

1-800-668-2268

Page 12