- ページ 10

スイッチ Allied Telesis AT-x230-10GPのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Allied Telesis AT-x230-10GP 14 ページ。 Rack mount installation guide

AT-x230-10GP, AT-AR3050S and AT-AR4050S Rack Mount Installation Guide

How to install the

device

You will need an AT-RKMT-J15 rack mount kit to install one or two side-

by-side devices in a 19-inch equipment rack. The rack mount kit can be

purchased from your Allied Telesis dealer.

To install a device in the equipment rack, follow these steps:

1. If rubber feet are attached to the base of the device, place the unit

upside down on a level, secure surface.

2. Remove the rubber feet with a screwdriver (Figure 1).

1. R

IGURE

EMOVING THE RUBBER FEET FROM THE DEVICE

3. Turn the device back over.

4. Installing the tray chassis in a 19-inch equipment rack (Figure 2)

Mount the tray chassis to a desired location in a 19-inch equipment

rack using four equipment rack screws. The rack screws are supplied

with the equipment rack.

Note

At the time of installation, do not loosen the tray fixing screws.