- ページ 10

対流式オーブン CPG 351FEC200DKのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CPG 351FEC200DK 11 ページ。 Electric convection ovens

User Manual

351FEC100(B/C/D/E) | 351FEC200(B/C/D/E)K

Operating Instructions

High Limit

Temperature Reset

WARNING:

PLEASE UNPLUG AND

DISCONNECT UNIT BEFORE REMOVING

THE BOLT AND OPENING THE CONTROL

PANEL TO AVOID INJURY.

1. Remove the 7mm bolt that secures the

control panel. (Fig. 1/2)

2. Open the control panel by carefully pulling

down, lowering it from the top. (Fig. 3)

3. Reset the temperature limiter.

The temperature limiter is installed on a small

bracket behind the control panel (Fig. 4).

Press the reset button manually.

The unit will operate under the new settings

once powered on.

4. Close the control panel and re-install the

7mm bolt to secure.

5. Power the unit on for inspection.

Warnings

1. Always ensure proper supervision while the equipment is in use.

2. Simple adjustments to knobs, leg height, etc. do not require assistance from specialized personnel.

For more technical adjustments, please consult a qualified technician.

3. Use only parts and accessories recommended by Cooking Performance Group.

4. During the initial uses of the equipment, an acrid or burning smell may be detected. This will

disappear after two or three uses. Or set unit to 450-500°F for 30 min. or until smell starts to

disappear, then turn unit off and let cool.

5. The equipment will remain hot for a short time after use (residual heat). Avoid all physical contact

with the unit during this time to prevent injury.

6. This equipment is strictly for professional use and must be used by qualified personnel.

7. The installation, startup, and maintenance of this equipment must be carried out by a qualified

technician.

8. All installation must be carried out according to the law. Cooking Performance Group is not

responsible for damages due to an incorrect installation, improper maintenance, or incorrect use.

•

These are very important regulations; if they are neglected, the equipment may not perform

properly or the user may be placed at risk and void manufacturer warranty.

Fig. 1

Fig. 3

Fig. 2

Fig. 4