- ページ 18
スイッチ Allied Telesis CentreCOM GS980M SeriesのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Allied Telesis CentreCOM GS980M Series 20 ページ。 Gigabit ethernet switches
ページを印刷する
For workstations without a DB-9 connector, such as laptop
computers, Allied Telesis offers the VT-Kit3 management cable. It
has a USB-A male connector that connects to a USB port on your
workstation. The cable requires a software driver from Allied Telesis.
The VT-Kit3 management cable is sold separately.
To start a local management session, perform the following
procedure:
1. Connect the RJ-45 end of the management card included with
the switch to the Console RS-232 port on the management panel.
2. Connect the other end of the cable to an RS-232 port on a
terminal or personal computer with a terminal emulation program.
3. Configure the VT-100 terminal or terminal emulation program as
follows:
Default baud rate: 9600 bps (The baud rates of the Console port
are 9600, 19200, 38400, 57600, and 115200 bps.)
Data bits: 8
Parity: None
Stop bits: 1
Flow controller: None
4. Press Enter. You are prompted for a user name and password.
5. Enter the default user name and password. They are "manager"
and "friend" (without quotes), respectively. The user name and
password are case sensitive. The local management session
starts when the User Exec mode awplus> prompt is displayed.
For more information, refer to the
GS980M Series Switches, AlliedWare Plus Operating
System
from www.alliedtelesis.com/us/en/services-support.
Troubleshooting
Problem: All port and system LEDs are off, and the has stopped.
Solutions: The unit is not receiving power. Try the following:
Verify that the power cord is securely connected to the power
source and the AC connector on the back panel of the switch.
Verify that the power outlet has power by connecting another
device to it.
18
Software Reference for
CentreCOM GS980M Series Quick Installation Guide