- ページ 5

グリドル CPG 351GTCPG24NLのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CPG 351GTCPG24NL 14 ページ。 Gas countertop griddles
CPG 351GTCPG24NL にも：変換マニュアル (6 ページ)

USER MANUAL

GAS CONNECTION

NOTE:

This griddle ships from the factory configured for areas with an altitude that is lower than 6,500 feet.

Ensure gas supply and gas type, as shown on unit serial plate agree. Unit installation must conform with the

National Fuel Gas Code, ANSI Z223.1/NFPA 54, the National Gas Installation Code, CSA-B149.1, or the Propane

Installation Code, CSA-B149.2 as applicable and in accordance with local codes.

A manual gas shut-off valve must be installed in the gas supply line ahead of the appliance and gas pressure

regulator for safety and ease in servicing.

The gas pressure regulator supplied must be installed on the appliance prior to connecting the equipment

to the gas line. Failure to install a regulator could be potentially hazardous and will void limited equipment

warranty.

Pipe threading compound must be resistant to the action of liquefied petroleum gases.

CAUTION:

Do NOT use an open flame to check for leaks. Check all gas piping for leaks with a soap and water

solution prior to operating unit.

The following instructions are for the conversion from Natural Gas to Propane (L.P.) on all models. The conversion

should be done before connecting the unit to the gas supply. It is recommended that an authorized service

agency perform this conversion.

Remove the knobs and front

panel. (Fig. 1)

Unscrew bolts and pilot valve,

then remove the manifold. (Fig. 2)

Replace the orifice fittings into

the valve. (Fig. 3)

Install the front panel knobs.

Before installing the regulator

(Fig. 4), unscrew the octagonal cap

(Fig. 5). If you can read NAT on the

plastic insert, flip it over and snap

back in place. It should now read

LP. (Fig. 6)

FIG. 1

FIG. 3

FIG. 5

FIG. 2

FIG. 4

FIG. 6