- ページ 3

コンピュータ・ハードウェア DFRobot DFR0004のPDF マニュアルをオンラインで閲覧またはダウンロードできます。DFRobot DFR0004 11 ページ。 Dfrduino romeo-all in one controller
DFRobot DFR0004 にも：マニュアル (13 ページ), マニュアル (16 ページ)

ページを印刷する

Applying Power

This is one of the most important steps in getting the Romeo up and communicating with your

host controller. You MUST make sure that you apply power to the Power Terminal using the

correct polarity. Reverse Polarity will damage the Romeo. We are not responsible for such

damage, nor do we warranty against such damage. Make sure you take time to apply power

correctly. Otherwise, it could get costly for you!

Power from USB: Simply plug USB cable, and the Romeo is able to work. Please notice that

the USB can only supply 500 mA current. It should be able to meet the most requirements for

LED lit application. However it is not enough to power DC motors or servo.

Power from Motor Power Input: Simply connect the ground wire from your supply to the

screw terminal labeled "GND", and then connect the positive wire from your supply to the screw

terminal labeled "VIN".

NOTE: Maximum supply voltage cannot exceed 14V DC.

Software

RoMeo can be programmed by Arduino IDE 0022 and above. It can be downloaded at

Arduino.cc (http://arduino.cc/en/Main/Software), Please select "Arduino UNO" as the hardware.

Romeo Configuration

Servo Power Select Jumper

As most servos draw more current than the USB power source can supply. A separate servo

power terminal is provided to power the servo individually. This option can be Enabled/Disabled

by the Servo Power Select Jumper.

When the Servo Power Select Jumper is applied, the servo is powered by internal 5V.

When the Servo Power Select Jumper is not applied, the servo is powered by external power

source.

The Romeo V1.0 uses an automatic switcher for the power source selection. When the external

power source has been applied, the servo will be automatically powered by the external power

instead of USB power.

Motor Control Pin Jumper

Applying the Motor Control Pin Jumpers will allocate Pin 5,6,7,8 for motor control.

Removing the jumpers will release the above Pins, and the motor controller will be disabled.

Tutorial

Button Press

RoMeo has 5 build in buttons S1S5 (Figure 2). S1S5 use analog input 7,

"Button Pin Map"

Function

Analog Pin 7

Button S1S5