- ページ 9

スイッチ Allied Telesis Rapier 16F-FX/MTのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Allied Telesis Rapier 16F-FX/MT 13 ページ。 Rapier switch
Allied Telesis Rapier 16F-FX/MT にも：クイック・インストール・マニュアル (11 ページ), クイック・インストール・マニュアル (12 ページ)

Quick Install Guide

C613-04017-01 REV G

See the Rapier Switch Software Reference for more information on start-up

and configuration procedures (including a list of message definitions).

Using the GUI to configure a switch

This section describes how to access the GUI from a PC via VLAN1, in

order to configure the switch. It assumes that the PC and the switch are in

the same subnet. By default, all switch ports are members of VLAN1.

The GUI requires a PC and web browser. Supported browsers are Internet

Explorer 5.0 and greater, or Netscape 6.2.2 or 6.2.3, with JavaScript enabled.

Internet Explorer can be found on the Documentation and Tools CD-ROM

that is bundled with your switch.

Connect the PC to a switch port.

The PC can be connected directly, or through your LAN.

To connect the PC directly to the switch, use a straight-through Ethernet

cable to connect an Ethernet card on the PC to any one of the switch ports.

Note the PC's IP address and mask.

Rapier

To connect via a LAN, use an Ethernet cable to connect the switch port(s) to

the device(s) on the LAN. Select the LAN PC from which you wish to

configure the switch. The PC should be in the same subnet as the part of

the LAN that contains the switch (for example, the PC could be connected

to a hub or Layer 2 switch that is directly connected to one of the switch's

ports). Note the PC's IP address and mask.

Access the CLI on the switch.

Follow the instructions in the previous "Using the CLI to configure a

switch" section.

Enable IP.

At the CLI, enter the command:

ENABLE IP

Assign an IP address to VLAN1.

Assign the VLAN1 interface an IP address in the subnet that the PC uses,

using the command:

ADD IP INTERFACE=vlan1 IP=ipaddress MASK=mask