- ページ 8

ネットワーク・ルーター Allied Telesis AR725のPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Allied Telesis AR725 13 ページ。 Ar700 series router

Change the password as soon as possible. Leaving the manager account with

the default password is a serious security risk. Make sure you remember the

new password as there is no way to retrieve it if it is lost.

Use the following command to change the account password:

set password

Use the following commands to save the configuration with the newly

created password, and set the router to use it on bootup:

create config=your-name.cfg

set config=your-name.cfg

To display a list of help topics, enter:

help

To display help on a specific topic, enter:

help topic

Alternatively, type a question mark (?) at the end of a partially completed

command to see a list of valid options.

See the AR Series Router Software Reference for more information on router

start-up and configuration procedures (including a list of message

definitions).

Using the GUI to configure a router:

This section describes how to establish a connection to the router through the

GUI, so you can configure the router before installing it in your LAN. For more

information about the GUI, see the AR700 Series User Guide.

Select a PC to browse to the

You can browse to the router from any PC that is running a supported

operating system with a supported browser installed. JavaScript must be

enabled.

You need to know the PC's subnet.

Connect the PC to the

Use an Ethernet cable to connect an Ethernet card on the PC to the eth0

port (see Figure 3).

You can browse to the router through any ETH port, as long as you give that interface

an IP address (see below). These instructions assume you will use eth0 as the LAN

interface.

router

from

router

AR700 Series Router

Software Release 2.6.1

C613-04027-01 REV E