- ページ 9

水ポンプ CPS Pro-Set VP10DのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。CPS Pro-Set VP10D 10 ページ。 Dual stage vacuum pump

5. Connect vacuum pump as shown in Figure - 1.

6. Open manifold valves.

7. Turn vacuum pump power switch "ON".

8. Run vacuum pump until final vacuum level is met.

9. Once the final vacuum level is reached, close manifold valves, turn power switch

"OFF".

It is recommended to change the vacuum pump oil after 50 hours of usage. The purity of

the oil will determine the final vacuum level achieved. Always use the CPS recommended

vacuum pump oil (VPOQ / VPOP / VPOG). The oil provided with the pump has been

specially blended to maintain maximum visosity at normal running temperatures as well

as cold weather starts.

OIL CHANGE PROCEDURES:

1. Be sure the pump oil is warmed up. if not warm, turn vacuum pump "ON" for 10

minutes.

2. Make sure vacuum pump is not plugged in.

3. Remove the oil drain cap and drain the contaminated oil into a suitable container. Tilt

the vacuum pump toward the oil drain port.

4. Once all the oil has been drained, re-secure the oil drain cap back onto the oil drain

port.

5. Remove the exhaust / oil fill cap and add oil until it is seen in the middle of the oil sight

glass. Re-secure exhaust/oil fill cap.

VACUUM OPERATION COMPLETE

Routine Maintenance

OPERATION