- ページ 3
ノートパソコン Dell 1555 - Studio - ChainlinkのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Dell 1555 - Studio - Chainlink 50 ページ。
Dell 1555 - Studio - Chainlink にも: サービスマニュアル (50 ページ)
Back to Contents Page
Before You Begin
Dell Studio™ 1555 Service Manual
Recommended Tools
Turning Off Your Computer
Before Working Inside Your Computer
This document provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that:
You have performed the steps in
l
You have read the safety information that shipped with your computer.
l
When replacing a component, you have already removed the original component, if installed.
l
Recommended Tools
The procedures in this document may require the following tools:
Small flat-blade screwdriver
l
Phillips screwdriver
l
Small plastic scribe
l
BIOS upgrade CD (see the Dell Support website at support.dell.com)
l
Turning Off Your Computer
CAUTION:
To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.
1. Save and close all open files and exit all open programs.
®
2. In Microsoft
Windows Vista
The computer turns off after the operating system shutdown process finishes.
3. Ensure that the computer and any attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your operating system, press and hold the power button for at least 8 to 10 seconds until the computer turns off.
Before Working Inside Your Computer
Use the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
CAUTION:
Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges. Hold a
component such as a processor by its edges, not by its pins.
CAUTION:
When disconnecting a cable, pull on the cable's connector or on its pull-tab, not on the cable itself. For cable connectors with locking
tabs, press inward on the locking tabs to release the connector. When connecting a cable, ensure that the connectors are correctly oriented and
aligned to avoid damage to the connector and/or the connector's pins.
1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.
2. Turn off your computer (see
Before Working Inside Your
Computer.
®
, click Start
, click the arrow
Turning Off Your
Computer).
, and then click Shut Down.