- ページ 2

水ポンプ DGSI TR-977のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。DGSI TR-977 2 ページ。 Srx-r pumps

Internal foam packaging

4. Now remove the pump body by simultaneously twisting the valve assembly

and pulling at the same time until the pump and the body easily separates.

5. Once separated, remove the upper-and-lower protective foam packaging.

Note: This packaging is provided to protect both the float and control rod from

damage during shipping. DGSI recommends that you save this packaging as

well as the box for any future shipping requirements.

To reassemble the pump, follow the above steps in reverse order. When

installing the bottom check-valve, it is recommended that you stand the pump

upside-down on the discharge hose-barb, then tighten the two bolts to pull the

O-ring seals into place.

Additional drawings and parts lists can be found at www.DGSI.info

Note: Some parts

listed are sold

only as a kit.

Maintenance

To clean the internal components

of the pump, remove the housing

as outlined in steps 1 – 4 in Packing

and Unpacking, then remove the

cotter and clevis pins from the

bottom assembly before sliding

the "T" assembly from the center

discharge tube.

The control rod and float can

now be removed for cleaning.

The float springs must first be

removed from the float (see

illustration below, #29).

Remove the barbed fittings to

clean the exhaust and air-inlet

valves from any debris.

To reassemble the pump, follow the above steps in reverse order.

Warning: Any further disassembly should be carried out by DGSI.