- ページ 16

ノートパソコン Dell Inspiron 1000のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Dell Inspiron 1000 46 ページ。 Dell vostro 1000 quick setup guide
Dell Inspiron 1000 にも：セットアップマニュアル (2 ページ), ハードドライブの取り外し (9 ページ), 仕様 (2 ページ), セットアップマニュアル (2 ページ), セットアップマニュアル (2 ページ), コンピュータのセットアップ (2 ページ), コンピュータのセットアップ (2 ページ)

ページを印刷する

1 M2.5 x 5-mm screws (2)

4 grounding-wire and captive

screw

7 standby switch

12. Lift the display up and away from the computer.

NOTICE:

The standby switch is fragile and easily broken. Avoid knocking the switch when removing and replacing the display.

Replacing the Display Assembly

NOTE:

Ensure the display and antenna cables are not twisted and are clear of the computer base before replacing the display.

1. Place the display onto the computer base.

2. Replace the two M2.5 x 5-mm screws in the display hinge.

3. Securely route the display cable under the tabs in the cable channel.

4. Connect the display cable to the system board and tighten the captive screw.

5. Securely route the antenna cables under the tabs in the antenna cable channel. If a Mini-Card is installed, connect the antenna cables to the card (see

Replacing a

Mini-Card).

6. Replace the keyboard (see

7. Replace the hinge cover (see

8. Close the display.

9. Replace the two M2.5 x 8-mm screws in the back of the computer and replace the two screw covers.

10. Turn the computer over and replace the two M2.5 x 8-mm screws in the bottom of the computer.

Display Bezel

CAUTION:

Before you begin the following procedure, follow the safety instructions in the Product Information Guide.

2 display cable

5 antenna cables (2)

8 display cable connector on

system board

Replacing the

Keyboard).

Replacing the Hinge

Cover).

3 display cable pull-

tab

6 antenna cable

channel

9 display cable

channel