- ページ 3

ボードゲーム DGT Bluetooth e-BoardのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DGT Bluetooth e-Board 15 ページ。
DGT Bluetooth e-Board にも：マニュアル (9 ページ), マニュアル (8 ページ)

ページを印刷する

Contents of the gift box

The gift box should contain following items.

1 DGT Bluetooth e-Board (Wood specifications should be marked on the outside of the gift box)

1 Set of DGT electronic chess pieces with 17 pieces of each colour (Two queens per colour)

1 Drawstring bag

1 High quality USB cable of 2 meters length

1 Euro USB power charger (and international adapter if required)

1 Clock cable to connect the e-Board to a DGT3000 (or DGT XL) clock

1 CD with the drivers for the board, additional DGT information and manuals

1 CD with a version of the Fritz chess program developed by ChessBase

1 Bluetooth installation manual (this manual)

In case items are missing or damaged, please contact your supplier.

Setting up your DGT Bluetooth e-Board

Important: If the battery is not fully charged it may be necessary to charge it before you can use the Bluetooth

functionality of the e-Board. To charge the battery, use the USB cable (included) to connect the board to a computer

or to the included USB power adapter. Charging of an empty board battery may take up to 24 hours.

After pressing the power button (on the side of the board), the board will automatically switch on.

Many computer USB ports, especially laptop USB ports, do not supply sufficient current or voltage to charge the board

at the maximum rate. Changing the computer power saving mode settings may improve the charging power

functionality. For details please review the documentation of your PC or laptop.

If the power charging from the computer is not sufficient, the LED will blink red instead of blinking orange. Apart from

the longer charging time there normally is no real problem if you leave the board plugged in for about 24 hours. Please

check if the LED turned green after this time which indicates that the board has been charged slowly but sufficient.

Charging via the mains adapter and the supplied USB cable will show a blinking orange LED (when no Bluetooth

connection is set-up) or a constant orange LED (when a Bluetooth connection is set-up).

Please use only the included high quality USB cable. Do not use longer USB cables for charging as this may NOT

provide enough current or voltage to charge the e-Board.

Power button options

Short push

Push and hold for 2 seconds

Push and hold for 10 seconds The board will perform a "cold" start and will reset all its parameters.

LED status indication

state

Colour and blink

mode LED

Board is ON

Constant

Blinking 0.5 – 0.5

Board is OFF

Flashing 1.9 sec off

– 0.1 sec on

Location of the e-Board

The detection of the electronic chess pieces is done by electromagnetic resonance. This means that proper

functioning of the e-Board may be influenced by external electromagnetic fields. Such fields can be caused by large

(plasma) monitors, loudspeakers or other devices with magnets or coils. Also strong RF transmitters within the e-

Board area may cause incorrect piece detection or "ghost pieces" and as such impact the result of your chess game.

MA_ENG_Bluetooth Installation Manual_Rev 1508

The board switches on / off

The board will display the power status on a connected DGT3000 or DGTXL clock

Red (undesirable

situation)

Bootloader mode

Charging failure

Orange (charging)

Charging +

communication

Charging + no

communication

Charging, board is

OFF

Green (charging

complete, or battery

charge sufficient)

Board ON +

communication

Board ON + no

communication

Board off, battery fully

charged