- ページ 30
ノートパソコン Dell Inspiron N5110のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Dell Inspiron N5110 47 ページ。
ページを印刷するBack to Contents Page
Wireless Mini-Card(s)
Dell™ Inspiron™ N5110 Service Manual
Removing the Mini-Card(s)
Replacing the Mini-Card(s)
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer has one full Mini-Card slot for Wireless Wide Area Network (WWAN) and one half Mini-Card slot for Worldwide Interoperability for Microwave
Access (WiMax/WLAN).
NOTE:
Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed.
Removing the Mini-Card(s)
1. Follow the instructions in
Before You
2. Remove the battery (see
Removing the
3. If you are removing the WiMax/WWAN Mini-Card:
a. Remove the module cover (see
b. Disconnect the antenna cables from the Mini-Card.
c. Remove the screw that secures the Mini-Card to the system board.
d. Lift the Mini-Card out of the system-board connector.
4. If you are removing the WLAN Mini-Card:
a. Follow the instructions from
b. Disconnect the antenna cables from the Mini-Card.
c. Remove the screw that secures the Mini-Card to the system board.
d. Lift the Mini-Card out of the system-board connector.
1 antenna cables (2) 2 Mini-Card
3 screw
4 system-board connector
Begin.
Battery).
Removing the Module
Cover).
step 3
to
step 9
in
Removing the Palm-Rest
Removing the
Battery) before working inside the
Assembly.