- ページ 4

ネットワーク・ハードウェア Allied Telesis AR400 SeriesのPDF 安全情報マニュアルをオンラインで閲覧またはダウンロードできます。Allied Telesis AR400 Series 18 ページ。 How to set up pppoe between a linux client and access concentrator
Allied Telesis AR400 Series にも：設定方法 (6 ページ), トラブルシューティングマニュアル (8 ページ), トラブルシューティング (5 ページ), クイック・インストール・マニュアル (8 ページ), クイック・インストール・マニュアル (12 ページ), ハウツー (8 ページ)

AR400 SERIES ROUTER

Safety

WARNING: In a domestic environment this product may cause radio interference in

which case the user may be required to take adequate measures.

ELECTRICAL NOTICES

WARNING: ELECTRIC SHOCK HAZARD

To prevent ELECTRIC shock , do not remove the cover. No user-serviceable parts inside.

This unit contains HAZARDOUS VOLTAGES and should only be opened by a trained

and qualified technician.

LIGHTNING DANGER

DANGER: DO NOT WORK on equipment or CABLES during periods of

LIGHTNING ACTIVITY.

CAUTION: POWER CORD IS USED AS A DISCONNECTION DEVICE. TO

DE-ENERGIZE EQUIPMENT, disconnect the power cord.

ELECTRICAL - TYPE CLASS 1 EQUIPMENT

THIS EQUIPMENT MUST BE EARTHED. Power plug must be connected to a properly

wired earth ground socket outlet. An improperly wired socket outlet could place

hazardous voltages on accessible metal parts.

PLUGGABLE EQUIPMENT, the socket outlet shall be installed near the equipment and

shall be easily accessible.

CAUTION: Air vents must not be blocked and must have free access to the room

ambient air for cooling.

OPERATING TEMPERATURE: This product is designed for a maximum ambient

temperature of 40 degrees C.

ALL COUNTRIES: Install product in accordance with local and

National Electrical Codes.

WARNING: Only trained and qualified personnel are allowed to install or replace

this equipment.

WARNING: As a safety precaution, a 10 Amp circuit breaker should be installed at the

supply end of the cable to be used with this LAN equipment.

ALWAYS connect the wiring to the LAN equipment first before connecting the wiring

to the breaker. To avoid the danger of physical injury from electrical shock, do not work

with HOT feeds. Always be sure that the breaker is in the OFF position before

connecting the wiring to the breaker.

ELECTRICAL - AC MAINS CIRCUIT OVERLOADING

When installing product, consideration must be given to the accumulative nameplate

ratings when connecting the equipment to the AC supply wiring.

Lithium Battery - Should only be changed by trained and qualified technicians.

CAUTION: Danger of explosion if battery incorrectly replaced. Replace only with the

same or equivalent type recommended by the manufacturer. Dispose of used batteries

according to the manufacturer's instructions.