- ページ 16

デスクトップ Dell Dimension 4700CのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Dell Dimension 4700C 42 ページ。 Dell desktop computer quick setup guide
Dell Dimension 4700C にも：クイック・セットアップ・マニュアル (2 ページ)

ページを印刷する

2. Lay the computer on its side so that the system board is on the bottom of the inside of the computer.

Open the computer

cover.

4. Disconnect the flex cable assembly from the back of the CD drive.

5. Remove the Flash Card Reader and bracket from its packaging.

6. Make sure the USB cable and IEEE 1394 cable are connected to the back of the media drive.

7. Press in on the release tabs at each end of the media bracket and slide the unit until it clicks in place.

8. Connect the USB cable on the back of the Flash Card Reader to the front-panel USB connector on the

9. Connect the IEEE 1394 cable on the back of the Flash Card Reader to the front-panel IEEE 1394 connector on the

10. Route the USB cable and the IEEE 1394 cable through the cable routing clip.

11. Reconnect the flex cable assembly to the back of the CD drive.

12.

Close the computer

cover.

Processor

Removing the Processor

NOTICE:

Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly could

damage your system board. For technical service, see "Contacting Dell" in the Owner's Manual.

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

system

board.

system

board.