- ページ 2
無線アクセスポイント Allied Telesis AT-MWS600APのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Allied Telesis AT-MWS600AP 2 ページ。 Simultaneous dual band access point
ページを印刷するHard-Surface Ceiling and Wall Installation
What to Prepare
AT-MWS600AP access point
Two screws to attach the access point directly
Mounting base
Two screws for the mounting base
Phillips-head screwdriver
Pencil
Note
Note
A Phillips-head screw driver and pencil are not included in the shipping box.
Installing the Access Point on a Hard-Surface Ceiling and Wall
To install the access point on the hard-surface celling or wall, perform the following
procedure:
Note
Note
Attaching the access point to the mounting base plate may not be easy once the
mounting base plate is installed on a ceiling or wall. Practice Step 11 to Step 12
before installing the mounting base plate on a ceiling or wall.
1.
Review the safety precautions.
2.
Attach the two screws to the access point.
3.
Apply the mounting base to the access point and adjust the height of the screws
where the access point can be turned to be secured to the mounting base.
4354
4.
Remove the mounting base from the access point.
5.
Connect an Ethernet cable.
6.
If you plan to use the AC adapter, connect it to the DC jack.
7.
If you are installing the access point on the wall, ensure that the orientation of the
mounting base is correct.
8.
Using the mounting base as a template, mark the two holes with a pencil where you
want to install the access point.
9.
Pre-drill the marked location on the hard-surface ceiling or wall.
10. Install the mounting base on the hard-surface ceiling or wall.
11. Insert the two screws on the access point to the holes on the mounting base.
12. Turn the access point until it is securely seated.
4353
4367
4
Ceiling T-Rail Installation
What to Prepare
AT-MWS600AP access point
Two rail clips, either narrow rail clips or wide rail clips
Two spacers
Two long screws for the rail clip with the spacer
Phillips-head screwdriver
Note
Note
A Phillips-head screw driver is not included in the shipping box.
Installing the Access Point on a Ceiling T-Rail
1.
Review the safety precautions.
2.
Attach two rail clips and the spacers to the access point using the long screws.
4354
3.
Connect an Ethernet cable.
4.
If you plan to use the AC adapter, connect it to the DC jack before going to Step 5.
5.
Align the rail clips on the access point to the ceiling T-rail and apply force to attach
the access point to the rail.
4355
5
4358
4361
6