- ページ 3
無線アクセスポイント Allied Telesis TQ6000のPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Allied Telesis TQ6000 4 ページ。 Gen2 wireless access point
ページを印刷するInstalling the Access Point on the Wall Mounting Bracket
1.
Align the bottom of the access point over the bracket so that the two screws on the
bottom of the device fit into the bracket keyholes.
2.
Slide the access point forward until its screws are seated in the bracket keyhole slots
and the bracket thumbscrew is aligned with the screw hole on the front panel.
3.
Tighten the thumbscrew to secure the access point to the wall mounting bracket.
4.
Place the Ethernet cable(s) and power cable (if any) along the cable guides inside of
the top cover in the cable hiding space.
Installing an Anti-theft Device
Installation of an anti-theft cable/lock is optional.
Note
Anti-theft devices are not available from Allied Telesis.
1.
Follow the instructions provided with the vendor's anti-theft device for the
installation.
Kensington
Lock Port
Starting the Initial Management Session
The access point firmware includes a DHCP client. The default setting for the client is
enabled. When you power on the access point for the first time, it queries the subnet on the
LAN port for a DHCP server. If a DHCP server responds to its query, the unit uses the IP
address the server assigns to it.
If there is no DHCP server, the access point uses the default IP address:
192.168.1.230.
To start the initial management session, perform the following procedure:
1.
Start the web browser on your management workstation.
2.
Enter the IP address of the wireless access point in the URL field of the web
browser. The address is one of the following:
If your network does not have a DHCP server, enter the default address
192.168.1.230.
If your network has a DHCP server, enter the IP address the DHCP server
assigned to the access point.
The wireless access point displays the logon prompt.
3.
Enter "manager" for the username and "friend" for the password. The username and
password are case-sensitive.
7
Setting the Country Setting
The non-US model of this product has a country code setting that must be set during the
initial management session of the unit. The setting ensures that the unit operates in
compliance with the laws and regulations of your country or region.
The country code for the US model is preset and cannot be changed. Per FCC
regulations, the country code setting for all WiFi products marketed in the US must be
fixed to US operational channels only.
LEDs
The top panel LEDs are described in this table.
LED Status Information
LED
State
Green
The access point is powered on and operating normally.
Blinking Green
The access point is booting up.
PWR/
Red
The access point has encountered a fault condition.
SYS
Blinking Red
The access point is updating its firmware.
OFF
The access point is not receiving power.
Green
The port has established a valid link to a network
device.
LAN 1
Blinking Green
The port is transmitting or receiving data.
and
Amber
The port is connected to a PoE+ power sourcing
LAN 2
equipment.
OFF
The port has not established a link to a network device.
Green
The 2.4GHz radio is enabled.
2.4GHz
OFF
The 2.4GHz radio is disabled.
Solid Green
The 5GHz radio is enabled.
5GHz
OFF
The 5GHz radio is disabled.
8
Description
9