- ページ 4

ソフトウェア Allied Telesis AR441SのPDF リリースノートをオンラインで閲覧またはダウンロードできます。Allied Telesis AR441S 14 ページ。 54266-02 patch release note
Allied Telesis AR441S にも：リリースノート (6 ページ)

ページを印刷する

Features in 54266-02

PCR: 40466

Module: ISAKMP

When the router was the initiator in an ISAKMP Quick mode exchange with

a PC running Windows 2000 or Windows XP, the IPSEC communication

would not establish successfully. This was because the Windows PC set the

commit bit in the exchange, but sent the CONNECTED Notify payload in

the Quick mode exchange. However, the router was waiting for an

Informational Exchange containing a Notify payload (with the

CONNECTED Notify Message) as specified by RFC 2408. Because an

Informational message was expected, the device did not process the Quick

mode CONNECTED message, and so the exchange was never committed.

Although this behaviour is described as "not required by the IKE standard"

[http://www.microsoft.com/technet/community/columns/cableguy/

cg0602.mspx], the device will now process CONNECTED messages

received in Quick mode exchanges, to allow interoperability with other

vendors.

PCR: 40470

Module: BGP

When BGP redistributed routes, locally imported routes were selected

rather than peer learnt routes. This issue has been resolved.

PCR: 40479

Module: OSPF

For OSPF-originated routes, it was possible for a route to be deleted from

the IP routing table, but still be referenced by OSPF. This could cause a

router reboot when later generating a summary LSA that contained the old

route. This occurred using the reset ip command. This issue has been

resolved.

PCR: 40496

Module: DHCP

When DHCP is enabled, it reclaims IP addresses at router startup to

determine if the addresses are in use or not. If, during this process, DHCP

was disabled then re-enabled, the router would not attempt to reclaim the

remaining IP address ranges. This would lead to the rejection of DHCP

requests for IP addresses that were still being reclaimed. This issue has been

resolved.

PCR: 40516

Module: DHCP

While initialising a range, the router acting as a DHCP server may release a

dynamic entry incorrectly. This issue has been resolved.

PCR: 40520

Module: DVMRP

Multicast data could not flow from PIM to DVMRP on a PIM/DVMRP

border router. This issue has been resolved.

PCR: 40530

Module: IPG

When both Load Balancer and Firewall were configured, the very first TCP

session was established after rebooting. Subsequent TCP session startup

packets may have been routed out to an incorrect interface causing sessions

to not be established. This issue has been resolved.

Patch Release Note

Level: 2

Patch 54266-02

C613-10417-00 Rev B