- ページ 6

サーバー Dell Dimension 2200のPDF 交換マニュアルをオンラインで閲覧またはダウンロードできます。Dell Dimension 2200 9 ページ。 Vga card installation instructions
Dell Dimension 2200 にも：インストレーション・インストラクション (1 ページ), マニュアル (50 ページ)

ページを印刷する

Dell PowerEdge 2200 Systems Microprocessor Replacement

6. Install the new microprocessor module.

a. Make sure the new microprocessor-module retention latches are in a

protracted position so that the retention latches will snap into position

when the microprocessor module is installed.

b. Align the microprocessor module with the microprocessor retention

bracket on the system board.

c. Lower the microprocessor module into the microprocessor retention

bracket, and press firmly on the top of the module until the module is

fully seated and the retention latches snap into position (see Figure 5).

temperature

sensor cable

Figure 5. Installing a Microprocessor Module

7. Reinstall the two screws securing the microprocessor-module heat sink

to the system board assembly.

Stand the system upright, and reinstall the two hexagonal screws in the

system board assembly.

8. Change the microprocessor speed jumper setting to correspond to the

new microprocessor's operating frequency.

The microprocessor speed jumper should be set for the installed micro-

processor's rated internal speed. For a 300-MHz Pentium II processor, a

jumper plug should be installed on the jumper labeled "RSVD1." For a

333-MHz Pentium II processor, a jumper plug should be installed on the

jumper labeled "RSVD2" (see "System Board Jumpers" found later in this

document).

NOTE: The system BIOS revision must be A05 or higher to use the RSVD1

and RSVD2 jumpers.

microprocessor module

microprocessor-module

retention latches (2)

microprocessor

retention bracket

heat sink