- ページ 5

サーバー Dell EMC PowerEdge MX740cのPDF リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Dell EMC PowerEdge MX740c 29 ページ。 Bios and uefi

ページを印刷する

System Setup details

The System Setup Main Menu screen details are explained as follows:

Option

Description

System BIOS

Enables you to configure BIOS settings.

iDRAC Settings

Enables you to configure the iDRAC settings.

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI

(Unified Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using

the iDRAC settings utility. For more information about this utility, see Integrated Dell Remote Access

Controller User's Guide at www.dell.com/idracmanuals.

Device Settings

Enables you to configure device settings such as network cards or storage controllers.

System BIOS

You can use the System BIOS screen to edit specific functions such as boot order, system password, setup password, set the

SATA and PCIe NVMe RAID mode, and enable or disable USB ports.

Viewing System BIOS

To view the System Setup screen, perform the following steps:

Steps

1. Turn on, or restart your system.

2. Press F2 immediately after you see the following message:

F2 = System Setup

NOTE:

If your operating system begins to load before you press F2, wait for the system to finish booting, and then

restart your system and try again.

3. On the System Setup Main Menu screen, click System BIOS.

System BIOS Settings details

About this task

The System BIOS Settings screen details are explained as follows:

Option

Description

System

Specifies information about the system such as the system model name, BIOS version, and Service Tag.

Information

Memory Settings Specifies information and options related to the installed memory.

Processor

Specifies information and options related to the processor such as speed and cache size.

Settings

SATA Settings

Specifies options to enable or disable the integrated SATA controller and ports.

NVMe Settings

Specifies options to change the NVMe settings. If the system contains the NVMe drives that you

want to configure in a RAID array, you must set both this field and the Embedded SATA field on the

SATA Settings menu to RAID mode. You might also need to change the Boot Mode setting to UEFI.

Otherwise, you should set this field to Non-RAID mode.

Boot Settings

Specifies options to specify the Boot mode (BIOS or UEFI). Enables you to modify UEFI and BIOS boot

settings.

Pre-operating system management applications