- ページ 19

サーバー Dell Force10 S2410のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S2410 31 ページ。 Installing the s2410 system
Dell Force10 S2410 にも：マニュアル (42 ページ)

ページを印刷する

Table 2-1. Pin Assignments Between the Console and a DTE Terminal Server

Console Port

RJ-45 to DB-9

Adapter

Signal

Port Pinout

Accessing the Ethernet Management Port

The S2410 includes the Ethernet Management port on the right front of the

chassis (labeled 10/100 Ethernet) that is dedicated to switch management. With

a standard RJ-45 Ethernet cable, connect it to any Ethernet port in your network

through which you can access the switch via a Telnet, SSH, SNMP, or Web

client.

For details on configuring the port (setting up an IP address to it) for

management access, refer to the

Default Configuration

A version of SFTOS is pre-loaded onto the chassis, however the system is not

configured when you power up for the first time (except for the default host

name, which is Force10). You must configure the system using the CLI.

Configure Layer 2 (Data Link) Mode

When the switch is first installed, all ports are disabled. To enable all ports in

Layer 2, enter the no shutdown all command in Global Config mode.

Alternatively, you can use the no shutdown command in Interface Config

mode.

Task

Enable the interface

SFTOS Configuration Guide for the S2410.

Command Syntax

no shutdown

Command Mode

Interface Config

Installing the Software