- ページ 14

サーバー Dell PowerEdgeのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge 20 ページ。 Vmware esxi software on servers
Dell PowerEdge にも：ポートフォリオ・マニュアル (27 ページ), クイックマニュアル (6 ページ), 使用マニュアル (44 ページ), システム管理マニュアル (28 ページ)

Linux driver installation

NOTE: The driver update disk (DUD) images are created only for those operating system releases in

which the native (in-box) driver is insufficient for installation. In the event that an operating system is

being installed with a corresponding DUD image, follow the instructions below. If not, proceed with

using the native device driver and then skip to the topic Installing or Updating the RPM Driver

Package With DKMS Support.

NOTE: This procedure is applicable for Red Hat Enterprise Linux 5 SP7 and SUSE Enterprise Linux 10

SP4.

NOTE: For SUSE Enterprise Linux 10 SP4 operating system installation, download the latest driver

from dell.com/support, and update the driver using the procedures detailed in this section.

Perform the following steps to install the RPM package with DKMS support:

Expand the gzipped tarball driver release package.

Install the DKMS package using the command: rpm –ihv megaraid_sas- <version> .noarch.rpm.

Install the driver package using the command: rpm –ihv megaraid_sas- <version> .noarch.rpm.

NOTE: Use rpm -Uvh <package name> when updating an existing package.

If the previous device driver is in use, you must restart the system for the updated driver to take

effect.

Verify that the driver is loaded with the following system commands: modinfo megaraid_sas and

dkms status.

NOTE: This procedure is applicable for Red Hat Enterprise Linux 6.5 SP2.

Perform the following steps to install the RPM package with KMOD support:

Expand the gzipped tarball driver release package.

Install the driver package using the command: rpm –ihv kmodmegaraid_ sas-<version>.rpm.

NOTE: Use rpm -Uvh <package name> when upgrading an existing package.

If the previous device driver is in use, you must restart the system for the updated driver to take

effect.

Verify that the driver is loaded with the following system commands: modinfo megaraid_sas.

NOTE: This procedure is applicable for SUSE Enterprise Linux 11 SP2.

Perform the following steps to install the RPM package with KMP support:

Expand the gzipped tarball driver release package.

Install the driver package using the command: rpm –ihv kmpmegaraid_ sas- <version>.rpm.

NOTE: Use rpm -Uvh <package name> when updating an existing package.