- ページ 2
サーバー Dell PowerEdge 1550のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge 1550 3 ページ。 Wake-on-lan (wol) support on dell servers
Dell PowerEdge 1550 にも： インストレーション・マニュアル (6 ページ), 情報更新 (12 ページ), インストレーション・マニュアル (24 ページ), セットアップと機能情報 (9 ページ), マニュアル (15 ページ), ユーザーマニュアル (34 ページ)
ページを印刷する
2.
Prepare the PERC 3/DC card for installation, and open the system cover. For instructions, see
your system's Installation and Troubleshooting Guide.
3.
Disconnect the power supply cable from the system board.
NOTE: Disconnecting the power supply cable will facilitate cable installation in step 9.
4.
Remove the SCSI backplane board from the chassis. For instructions, see your system's
Installation and Troubleshooting Guide.
5.
Connect one end of the short cable to the SCSI backplane board connector.
NOTE: If necessary, remove the old cable from the system board to the SCSI backplane board
before proceeding to step 6.
6.
Reinstall the SCSI backplane board in the chassis. For instructions, see your system's
Installation and Troubleshooting Guide.
7 .
Route the PERC 3/DC SCSI cable through the opening in the fan bracket and attach the connec-
tor to the PERC 3/DC card.
NOTE: To avoid damage to the cable by the sliding system cover, make sure that the SCSI cable
rests on the bottom of the chassis between the system board and the power supply.
8.
Install the PERC 3/DC card into peripheral component interconnect (PCI) slot 1, and then go to
step 9. If an existing PCI card is installed in PCI slot 1, perform the following steps:
a.
Loosen the existing PCI card thumbscrews at the back of the chassis.
b.
Grasp the existing PCI card in PCI slot 1 by its top corners and carefully remove it from the
PCI slot 1 connector.
c.
Insert the existing PCI card firmly into the PCI slot 2 connector until the card is fully seated.
d.
Tighten the existing PCI card thumbscrews at the back of the chassis.
e.
Grasp the PERC 3/DC card by its top corners and insert the card firmly into PCI slot 1 until
the card is fully seated.
f.
Tighten the PERC 3/DC card thumbscrews at the back of the chassis.
9.
Reconnect the power cable to the system board, ensuring that the SCSI cable is located
beneath the power cable to damage from the sliding system cover.
10. Connect the SCSI cables to the PERC 3/DC card and the existing PCI card, if applicable.
11. Close the system cover. For instructions, see your system's Installation and Troubleshooting
Guide.