- ページ 7

サーバー Dell PowerEdge 2410のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge 2410 10 ページ。 Cabling poweredge t610
Dell PowerEdge 2410 にも：マニュアル (20 ページ), マニュアル (20 ページ), マニュアル (17 ページ), マニュアル (12 ページ), マニュアル (10 ページ), マニュアル (9 ページ), マニュアル (9 ページ), マニュアル (10 ページ), マニュアル (12 ページ), マニュアル (11 ページ), マニュアル (8 ページ)

Cabling the Dell™ PowerEdge™ R610

4. Once all the cables are routed through the CMA, dress the cables between the back of the system and the

entrance of the CMA with the tie wraps provided in the CMA kit. The tie wraps are shown in yellow in all

illustrations.

5. Clip off the excess length of material from the tie wraps and make sure that the tie wraps are positioned to

avoid interference with adjacent systems.

6. Return the CMA to the closed (retracted) position.

7. Extend the system from the rack to verify there is sufficient slack in the cables at both the entrance and exit of

the CMA.

8. See Figure 5 for an example of a completed left side mounted CMA installation.

Figure 5: Completed Left Side Mounted CMA Installation

Right Side Mounting Instructions

Install the CMA on the right rear side of the rails by attaching both CMA housings to the attachment brackets on

the rails. Follow steps 2‐7 from the right side mounting instructions in the previous section. See Figure 6 for an

example of a completed right side mounted CMA installation.

Figure 6: Completed Right Side Mounted CMA Installation

Page 5