- ページ 23
サーバー Dell PowerEdge 2550のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge 2550 26 ページ。 Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2550 にも： インストールマニュアル (32 ページ), 設定マニュアル (10 ページ), ラック取り付け説明書 (40 ページ), アクティベーション・マニュアル (32 ページ), インストレーション・マニュアル (32 ページ), マニュアル (28 ページ), マニュアル (15 ページ)
ページを印刷する
support.dell.com
7 .
Secure the cables to the cable-management arm:
a.
After connecting the cables to the system, unscrew the thumbscrews that
secure the front of the server to the front vertical rail.
b.
Slide the system forward to the fully extended position.
c.
Route the cables along the cable-management arm, allowing some
additional cable slack at the hinge positions, and secure the cables to the
cable-management arm with the Velcro straps attached to the cable-
management arm.
8.
Slide the system in and out of the rack to verify that the cables are routed
correctly and do not bind, stretch, or pinch with the movement of the cable-
management arm.
NOTE: As you pull the system out to its furthest extension, the slide assemblies
will lock in the extended position. To push the system back into the rack, press
the green locking latch on the side of the slide to release the locks, and then slide
the system completely into the rack.
Replacing the Doors
This procedure provides instructions for replacing doors on Dell 24-U and 42-U racks.
If you have a Dell PowerEdge 4210 rack, see the procedures contained in the
Dell PowerEdge 4210 Rack Installation Guide.
CAUTION: To prevent personal injury due to the size and weight of the
doors, never attempt to remove or replace the doors by yourself.
To replace the 24-U rack's front and back doors, perform the following steps:
1.
Lift the front door into position and align the hinges with the hinge insert in the
rack as shown in Figure 1-4.
2.
Slide the hinge pins into the hinge insert in the rack until the hinges lock into
position.
3.
Verify that the hinges are latched.
4.
Close the door latch by rotating the handle counterclockwise until it stops (see
Figure 1-2).
5.
Repeat steps 1 through 4 to replace the back door.
To replace the 42-U rack's front and back doors, perform the following steps:
1.
Lift the front door into position and align the hinges with the holes in the rack as
shown in Figure 1-5.
2.
Slide the hinges into the holes in the rack until the hinge release levers lock the
hinges into position.
Rack Installation Guide
1-15