- ページ 10

サーバー Dell PowerEdge 300のPDF チェックマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge 300 27 ページ。 Power supply update
Dell PowerEdge 300 にも：更新 (2 ページ)

7-10

Installation and Troubleshooting Guide

To replace the bezel, fit the two retaining hooks on the bezel into their corresponding

slots at the bottom of the chassis. Then rotate the top of the bezel toward the chassis

until the top tabs snap into their corresponding slots on the bezel.

Removing and Replacing Front-Panel

Inserts

Empty 5.25-inch drive bays contain a front-panel insert to protect the inside of the

computer from dust particles and also to ensure proper airflow within the computer.

Before you install a drive in an empty drive bay, you must first remove the front-panel

insert (see Figure 7-8).

To remove the insert covering a drive bay, follow these steps:

Turn off the system, including any attached peripherals, and disconnect all the AC

power cables from their power sources.

Remove the computer cover as instructed in "Removing the Computer Cover,"

earlier in this chapter.

Remove the front bezel using the instructions in "Removing and Replacing the

Front Bezel,"earlier in this chapter.

With your thumbs, press in on each end of the insert until the insert snaps free of

the bezel.