- ページ 16

サーバー Dell POWEREDGE 4300のPDF アップグレードマニュアルをオンラインで閲覧またはダウンロードできます。Dell POWEREDGE 4300 24 ページ。 System board upgrade
Dell POWEREDGE 4300 にも：インストレーション情報 (6 ページ), インストレーション・マニュアル (28 ページ), ラックの設置 (37 ページ), アップグレード・インストール・マニュアル (14 ページ), ラックの設置 (34 ページ), アップグレードマニュアル (23 ページ), 取付説明書 (12 ページ), 交換マニュアル (3 ページ), インストレーション情報 (6 ページ), インストレーション・マニュアル (14 ページ)

1-12

Dell PowerEdge Systems — Microprocessor Upgrade

Remove the microprocessors.

See "Removing the Microprocessors", found later in this document.

Remove and replace the guide brackets.

See "Removing and Replacing the Guide Brackets", found later in this

document.

Install the upgrade microprocessor.

See "Installing the Upgrade Microprocessor", found later in this document.

Reassemble and check the system.

See "Reassembling and Checking the System", found later in this document.

!" #

To remove the current microprocessors from the system board, perform the follow-

ing steps.

Unscrew and remove the two large thumbscrew retention pins that secure the

microprocessor to the system board.

Press the microprocessor's release latches inward until they snap into position

(see Figure 1-4).

NOTE: Figure 1-4 illustrates the SEC cartridge. The heat sink on the single-edge

connector cartridge 2 (SECC2) package is different.

Grasp the microprocessor assembly firmly and pull it away from the microproces-

sor guide bracket assembly.

You must use up to 15 pounds (lb) of force to disengage the microprocessor

from the connector.