- ページ 5

ソフトウェア Allied Telesis AT-9800 SeriesのPDF リリースノートをオンラインで閲覧またはダウンロードできます。Allied Telesis AT-9800 Series 5 ページ。 How to set up pppoe between a linux client and access concentrator
Allied Telesis AT-9800 Series にも：設定方法 (9 ページ), クイック・インストール・マニュアル (12 ページ), ハウツー (8 ページ)

ページを印刷する

Release sb273-01

C613-10436-00 Rev A

CR00007521

Module: IPG

DVMRP packets were being dropped due to packet length inconsistencies

from other vendor devices.

This issue has been resolved. (No PCR number.)

CR00007686

Module: ATM

If ATM is receiving a OAM loopback cell (normal from an ISP) at regular

intervals then it may cause a reboot. This fix stops this behaviour and will

also stop some other random packet corruption.

This issue has been resolved. (PCR number: 50064)

CR00007716

Module: LOG

Previously, when changing the password on a log output/receive definition

to a shorter string, the log message exchange could fail.

This issue has been resolved. (PCR number: 50070)

CR00007760

Module: SWCX, SWITCH

When changing VLAN configuration on the Switchblade, MAC addresses

on the ports that move to a new VLAN need to be deleted. This address

deletion process has been made significantly more efficient, minimising the

impact on general switch operation.

This issue has been resolved. (No PCR number.)

Level 4

CR00006093

Module: FFS

There was not enough information displayed to the user when the

ACTIVATE FLASH COMPACTION command was entered at the same time

as Flash was compacting.

This issue has been resolved. (No PCR number.)

Enhancements

CR00006652

Module: IKMP, IPSEC

Previously ISAKMP NAT-T was enabled by default on every ISAKMP

policy created. NAT-T is now disabled by default on every ISAKMP policy.

(No PCR number.)

CR00006953

Module: PPP

The ability to configure Van Jacobson Header Compression over dynamic

PPP interfaces has been added. To this end, the command parameter

'VJC={ON|OFF}' has been added to the CREATE and SET PPP TEMPLATE

commands. (No PCR number.)

Level: 3

Level: 4