- ページ 13

サーバー Dell PowerEdge M520のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge M520 25 ページ。 Dell poweredge blade servers getting started guide
Dell PowerEdge M520 にも: 情報更新 (38 ページ), リリースノート (27 ページ), ユーザーマニュアル (23 ページ), 重要事項説明書 (35 ページ), 更新マニュアル (32 ページ), 更新マニュアル (28 ページ), ユーザーマニュアル (26 ページ), ユーザーマニュアル (22 ページ), スタートマニュアル (12 ページ), テクニカル・マニュアル (46 ページ), テクニカル・マニュアル (45 ページ), ポートフォリオ・マニュアル (27 ページ), スタートマニュアル (14 ページ), スタートマニュアル (12 ページ)

Dell PowerEdge M520 マニュアル
3
Command Line Interface (CLI) Reference
10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described
in this section after successfully connecting to the 10GbE PTM CLI according to the procedure
Section 2, "Connecting to the 10GbE PTM CLI," on page 9
described in
3.1

CLI Privilege Levels

The 10GbE PTM supports the following user privilege levels:
• USER - Common user level, indicated by the # prompt
• ADMIN - Administrator level, indicated by the & prompt
Different commands are available in different privilege levels. The command reference indicates
the required privilege level for each command that requires a privilege level higher than USER.
3.2

Quick Reference

Table 5 provides a quick reference to the CLI commands:
Table 5 - List of Commands
Command
name
General Commands
help
login
exit
reload
Software Image Commands
show image ver
copy image from-
file
Device Commands
show device temp Shows the temperature of a specified device
Port Commands
Short Description
Shows the list of available commands
Change privilege level
Exit current privilege level
Restart the module:
Hardware reset and software reload
Shows the software image version
Upload new software image to the PTM
Reference
Section 3.4.1, "help," on page 14
Section 3.4.2, "login (ADMIN)," on
page 15
Section 3.4.3, "exit," on page 15
Section 3.4.4, "reload," on page 15
Section 3.5.1, "show image ver," on
page 16
Section 3.5.2, "copy image from-file,"
on page 16
Section 3.6.1, "show device temp
(ADMIN)," on page 17
Rev 1.00
.
13