- ページ 9

サーバー Dell PowerEdge M520のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge M520 22 ページ。 Dell poweredge blade servers getting started guide
Dell PowerEdge M520 にも: 情報更新 (38 ページ), リリースノート (27 ページ), マニュアル (25 ページ), ユーザーマニュアル (23 ページ), 重要事項説明書 (35 ページ), 更新マニュアル (32 ページ), 更新マニュアル (28 ページ), ユーザーマニュアル (26 ページ), スタートマニュアル (12 ページ), テクニカル・マニュアル (46 ページ), テクニカル・マニュアル (45 ページ), ポートフォリオ・マニュアル (27 ページ), スタートマニュアル (14 ページ), スタートマニュアル (12 ページ)

Dell PowerEdge M520 ユーザーマニュアル
Dell -10GbE PTM
The PTM supports hot-insertion into the chassis. If the PTM is inserted to a powered chassis, the
power LED (green) should turn on immediately.

2.2.2 PTM Removal

The PTM supports hot-removal. It may be removed when the chassis is powered on or off.
The PTM must not be removed during a firmware update process.
Note: Firmware update is in progress when the amber LED is blinking.
2.3

Connecting the External Ports

The PTM front panel presents 16 SFP+ ports. Each port provides connectivity to a server with the
respective number. Figure 4 shows the front panel view of the PTM.
D
D
10 Gb Ethernet Pass Through II
D

2.3.1 10 Gigabit Ethernet SFP+ Modules

The PTM supports SFP+ modules for 10 Gigabit Ethernet, with 10GBASE-SR and 10GBASE-LR
PHYs. SFP+ modules must be approved for use with this PTM. Modules not approved may not
work. See Supported Optical Modules and DCAs on page 17 for lists of approved DCAs and opti-
cal modules.

2.3.2 Installation and Removal of Optical Transceiver Modules

Optical transceiver modules have a locking mechanism which can be opened or closed.
To insert the module into the cage:
1. Open the module's locking mechanism.
2. Make sure that the male connectors on the module aligns with the female connector inside of
the cage. Also check that there is no dirt or foreign matter in the module or in the cage.
3. Insert the module into the adapter card module cage.
4. Close the locking Mechanism.
To remove the module from the cage:
1. Unlock the locking mechanism by opening the handle.
2. Pull the module out of the cage.
Figure 4: Pass Through II Front Panel
Rev 1.0
9