- ページ 33

サーバー Dell PowerEdge R620のPDF インストール、メンテナンス、トラブルシューティングマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge R620 48 ページ。 Poweredge series
Dell PowerEdge R620 にも：マニュアル (11 ページ), スタートマニュアル (12 ページ), インストレーション・インストラクション (2 ページ), インストレーション・インストラクション (2 ページ), ポートフォリオ・マニュアル (27 ページ), スタートマニュアル (10 ページ)

Connecting to the customer network

The computer supports built-in ethernet ports that support network speeds of 10/100/1000

Mbps. However, for CMS installations, you must use only speeds of 10/100 Mbps. This ethernet

connection is used for CMS Supervisor, network printers, and LAN backup.

You must use ethernet port 0 for this connection.

The customer supplied Serial Attached SCSI (SAS) cable connects one of the SAS ports in

PCIe on the back of the computer to the SAS port on the rear of the customer supplied tape

drive.

Once you assemble the system, including the loose hardware that is shipped with the system

that you installed with help from CMS Provisioning, turn on the system and verify the results of

the Power-On Self Test (POST).

To turn on the system and verify POST:

1. Plug the power cord of the UPS into an AC outlet.

2. Turn on the power to the UPS.

3. Turn on tape drive.

4. Turn on the system monitor.

5. Press and release the power button.

6. The system boots.

After completing the physical installation of the system, the installation continues with software

provisioning. This is often done with the support of the Avaya CMS Provisioning group.

Provisioning the system consists of the following:

Setting up CMS

●

Avaya CMS Dell R720 and R620 Computer Hardware Installation

Turning on the system and verifying POST

October 2015