- ページ 5

サーバー Dell PowerVault 735NのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault 735N 26 ページ。 Nas appliances. boot hard-disk drive
Dell PowerVault 735N にも：補足マニュアル (3 ページ), ハードウェア交換マニュアル (10 ページ), 更新マニュアル (10 ページ), マニュアル (18 ページ), 更新マニュアル (12 ページ), 更新マニュアル (8 ページ), 交換取扱説明書 (19 ページ)

Safety Instructions

Use the following safety guidelines to ensure your own personal safety and to help

protect your server, storage system, or appliance from potential damage. For com-

plete safety, regulatory, and warranty information, refer to your system's System

Information booklet.

Notes, Notices, Cautions, and Warnings

Throughout this guide, blocks of text may be accompanied by an icon and printed in

bold type or in italic type. These blocks are notes, notices, cautions, and warnings,

and they are used as follows:

NOTE: A NOTE indicates important information that helps you make better use of

your computer system.

NOTICE: A NOTICE indicates either potential damage to hardware or loss

of data and tells you how to avoid the problem.

CAUTION: A CAUTION indicates a potentially hazardous situation which, if

not avoided, may result in minor or moderate injury.

WARNING: A WARNING indicates a potentially hazardous situation which,

if not avoided, could result in death or serious bodily injury.

Precautions for Rack-Mountable Products

Observe the following precautions for rack stability and safety. Also refer to the rack

installation documentation accompanying the system and the rack for specific warn-

ing and/or caution statements and procedures.

Servers, storage systems, and appliances are considered to be components in a rack.

Thus, "component" refers to any server, storage system, or appliance, as well as to

various peripherals or supporting hardware.

WARNING: Installing Dell system components in a Dell rack without the

front and side stabilizers installed could cause the rack to tip over, poten-

tially resulting in bodily injury under certain circumstances. Therefore,

always install the stabilizers before installing components in the rack.

iii