- ページ 7

サーバー Dell PowerVault DL4000のPDF 配備マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault DL4000 22 ページ。 Setting up your dell powervault dl4000 backup to disk appliance
Dell PowerVault DL4000 にも：ハンドブック (28 ページ), リリースノート (11 ページ), スタートマニュアル (10 ページ), マニュアル (4 ページ), マニュアル (2 ページ), システムを使い始める (2 ページ)

Figure 1. Setting the PowerVault MD1200 Storage Enclosure Configuration Switch

1. configuration switch

Connecting The Storage Enclosure To The PowerVault DL4000 System

Connect the data cable from the PowerEdge RAID Controller (PERC) installed in the PowerVault DL4000 system to the

primary Enclosure Management Module (EMM) SAS In port of the storage enclosure. For more information, see the

figure below.

Figure 2. Connecting the SAS Cable From the PowerVault DL4000 System to the PowerVault MD1200 Storage Enclosure

If the appliance includes a cable management arm (CMA), locate the CMA

CMA kit and follow the instructions to install the CMA.

After cabling the appliance, turn on the MD1200 storage enclosure, and then turn on the PowerVault DL4000 system.

NOTE: It is recommended that you connect the appliance to an uninterrupted power supply (UPS) for maximum

reliability and availability. For more information, see your system's

Installation Instructions that shipped with the

Owner's Manual at dell.com/support/manuals.