- ページ 29

サーバー Dell PowerVault MD3200 SeriesのPDF 配備マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault MD3200 Series 38 ページ。 Storage arrays
Dell PowerVault MD3200 Series にも：更新マニュアル (32 ページ), ラック取り付け説明書 (2 ページ), サポート・マトリックス (12 ページ), インストレーション・マニュアル (18 ページ), 配備マニュアル (38 ページ), 情報更新 (1 ページ), サポート・マトリックス (17 ページ), テクニカルマニュアルブック (40 ページ), ホワイトペーパー (22 ページ), 配備マニュアル (38 ページ)

Post Installation Tasks

Before using the Dell PowerVault MD storage array for the first time,

complete the set of initial configuration tasks in the order shown. These tasks

are performed using the MD Storage Manager (MDSM) software.

1 For out-of-band management, you must set the network configuration for

each RAID controller module, including its Internet Protocol (IP) address,

subnetwork mask (subnet mask), and gateway.

NOTE:

You can set the network configuration using a DHCP server.

2 Start MDSM.

•

Click StartProgramsDellMD Storage ManagerModular

Disk Storage Manager Client on Microsoft Windows operating

systems.

Click the PowerVault MD Storage Manager desktop icon on Linux

•

operating systems.

•

You can also launch PowerVault MD Storage Manager in Linux by

running the following commands at the command prompt:

cd/opt/dell/mdstoragesoftware/mdstoragemanager

/client./SMclient

3 Go to Setup Add Storage Array and start the automatic discovery of

systems in the Enterprise Management Window (EMW).

NOTE:

Only storage arrays configured with IP address on the same subnet as

the management stations will be detected.

NOTE:

It may take several minutes for the discovery process to complete.

Closing the Automatic Discovery Status window before this stops the

discovery process.

After discovery is complete, a confirmation screen is displayed.

4 Click Close to close the screen.

Post Installation Tasks