- ページ 9

サーバー Dell PowerVault NX1950のPDF アップグレードマニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerVault NX1950 18 ページ。 For vmware esx server software
Dell PowerVault NX1950 にも：配備マニュアル (34 ページ), 重要事項説明書 (26 ページ), はじめに (49 ページ), 設置およびトラブルシューティング・マニュアル (48 ページ), 配備マニュアル (38 ページ), リファレンス・マニュアル (4 ページ), セッティング (2 ページ), 使用 (2 ページ), 設定マニュアル (11 ページ)

Upgrading Your Dell PowerVault

NX1950 Integrated and Gateway

Solutions to Enable iSCSI

Active/Active Target

You can use the Microsoft

(iSCSI) Active/Active Target 3.1, to configure Active/Active Targets on your

Dell™ PowerVault™ NX1950 Integrated and Gateway solutions. To upgrade

the iSCSI Active/Active Target 3.1:

1 Perform the steps in "Planning" on page 10.

2 Perform the steps in "Uninstalling the Current Target" on page 10.

3 Perform the steps in "Creating a New Target" on page 12.

4 Creating a highly available iSCSI instance. For more information about

creating a highly available iSCSI instance, see the Dell PowerVault NX1950

Systems Deployment Guide located on the Dell Support website at

support.dell.com.

NOTE:

The upgrade procedures in this section are applicable to systems running in

a cluster configured with iSCSI Targets and .vhd files in the current active node.

You can also perform these upgrade procedures to upgrade the iSCSI Target on a

stand-alone system.

NOTE:

The term 3.0 Target refers to your current configuration of PowerVault NX1950

solution with iSCSI Active/Passive Target 3.0. The term 3.1 Target refers to the

PowerVault NX1950 configuration with Active/Active Target using iSCSI

Active/Active Target 3.1.

internet Small Computer System Interface

Configuring 3.1 Target